Olsberg Tellus Aqua plus Mode D'emploi page 34

To exit the menu:
•
Press the OFF button to exit the DATE menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.3 LANGUAGE
Setting the desired operating language.
Choices: German, English, French, Spanish and
Italian.
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to get into the menu.
•
Select Language by pressing
or .
•
Press ON to get to the settings.
The current language setting will flash.
•
Use or to change the language.
•
Press ON to confirm.
To exit the menu:
•
Press the OFF button to exit the menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.4 MENU TYPE
The manner in which the operating parameters P, V,
T are displayed can be selected here. Display mode
Rolling or Short can be selected.
Rolling:
The setting parameters appear one after the other in
the display.
In addition, the current measured room or buffer
temperature appears and when the desired room or
buffer temperature is reached or exceeded, the mes-
sage appears
THERMOSTAT ON
Short:
All setting parameters appear at the same time in the
display.
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to enter the menu.
+ at the
+ at the
34
•
Keep the pressed until the message MENU
TYPE appears.
•
Press ON to arrive at the settings.
The current menu type setting will flash.
•
Use or to change the menu type.
•
Press ON to confirm.
To exit the menu:
•
Press the OFF button to exit the MENU TYPE
menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.5 STANDBY
Here, you can switch standby mode on or off and set
the desired temperature at which it should switch on
again.
If Standby mode is ON, then the appliance is turned
off once the set room or buffer temperature t is
reached and when it falls beneath the set START
TEMPERATURE it is turned on again.
The temperature difference between the switch-on
and switch-off temperatures can be selected between
3° to 6°.
Example:
Room temperature SET T. ROOM
STARTTEMPERATUR
The unit switches off when the room temperature is
22°C and switches on again at 16°C.
If standby mode is OFF, then the unit does not switch
off when the set temperature is reached, but instead-
continues to heat at the lowest power setting.
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to get into the menu.
•
Press the button down until the message
STANDBY appears.
•
Press ON to get to the settings.
The current setting will flash.
•
Use the + buttons to select ON or OFF.
•
Confirm with ON and continue on to
STARTTEMPERATUR.
•
Use the + buttons to enter the desired
STARTTEMPERATUR (switching difference is 3
– 6°C) and confirm with ON.
To exit the menu:
•
Press the OFF button to exit the STANDBY
menu.
= 22°C Set
= 16°C
+ at the