Olsberg Tellus Aqua plus Mode D'emploi page 35

•
Press the OFF button to exit the SET STOVE
menu.
10.4.6 STATUS BUZZER
This enables the activation or deactivation of the
warning signal.
If an alarm message is displayed, the warning signal
remains even if the buzzer is deactivated.
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to arrive at the menu.
•
Keep the pressed until the message STATUS
BUZZER appears.
•
Press the ON button to get into the menu.
•
Use the + buttons to select ON or OFF.
•
Confirm with ON.
To exit the menu:
•
Press the OFF button to exit the STATUS
BUZZER menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.7 NIGHT TIME REDUCTION
Allows the setting of the temperature to which the
room or buffer should be heated, even when the ap-
pliance is in the off phase.
As a basic rule, the switching differential is 3K with
room temperature.
Example:
The set night time temperature is 10°C.
The unit switches on when the room temperature is
7 and switches off again at 10 .
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to get into the menu.
•
Press the button down until the messag SET
NIGHT T. appears.
•
Press the ON button to get into the menu.
The active operating mode flashes.
•
Use the + buttons to set the value of the
desired night time temperature or deactivate the
function with OFF.
+ at the
+ at the
35
•
Confirm with ON.
To exit the menu:
•
Press the OFF button to exit the SET NIGHT T.
menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.8 BLOCK BUTTONS
This enables blocking of the keypad of the operating
panel.
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to enter the menu.
•
Hold the button down until the message
KEYLOCK appears.
•
Press the ON button to get into the menu.
The active operating mode OFF flashes.
•
Use the + buttons to select ON or OFF.
•
Press ON to confirm.
To exit the menu:
•
Press the OFF button to exit the KEYLOCK
menu.
•
Press the OFF button to exit the SET STOVE
menu.
•
To activate or deactivate the BLOCK BUTTONS
function, press the ON and OFF buttons simulta-
neously.
10.4.9 RESET
Resets all operating entries back to the factory set-
tings in the menu SET STOVE.
Operational settings such as heat output, buffer or
room temperature remain the same.
•
Press the two arrow buttons
same time.
The message MENU SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to get into the menu.
•
Hold the button down until the message
RESET appears.
•
Press the ON button to arrive at the menu.
The current setting NO will flash.
•
Use the + buttons to select YES or NO.
•
Press ON to confirm.
+ at the
+ at the