Olsberg Tellus Aqua plus Mode D'emploi page 30

8.1 Permissible fuels
•
The pellet-buring chimney stove may only be
fueled with pellets that correspond to the certifi-
cation program DINplus or Austrian Norm M
7135.
Max. thickness = 7 mm
Max. length = 30mm
Max. moisture content 10%
•
The pellets must be stored in a dry and dust-free
environment.
•
When filling the pellets, please take care that the
pellet container of the unit is not filled with poten-
tially accumulated sawdust.
8.2 Please note before the first
heating
•
Ensure that all accessories are removed from the
ash collection tray and the combustion chamber.
•
The odour caused by the vapourising of the pro-
tective coating will disappear after the chimney
stove has been burning for several hours (venti-
late the room well).
•
The chimney stove is coated with a high-quality
temperature resistant lacquer, which achieves its
final hardness after the first firing.
- Therefore, do not place anything on the chimney
stove and do not come into contact with the sur-
faces, because this could cause damage to the
finish.
•
The chimney stove should only be operated with
the combustion chamber door closed.
•
Do not remove hot ashes. Ashes may only be
stored in fire-resistant, unflammable containers.
•
Important: The surfaces will be hot!
•
The precautionary measures regarding combus-
tion air supply may not be changed.
•
When the stove is new (or when the container is
completely empty) it might not light because the
pellet loading screw needs a few minutes to fill
up and feed the pellets.
8.3 Operation panel
All settings for heating operation, and service and
maintenance programs are entered into the operation
panel.
The commands are entered using the 4 buttons on
the control panel.
All operation parameters are shown on the display.
ok OFF
P=5 T=55° t=16°/22°
X
12:45
30
The 4 buttons have the following functions:
ON (ok) = start/change confirmation
OFF (x) = off/ends the entry mode/changes to
higher operation levels
= changes to next level / increases
the displayed value
= changes to next level / decreases
the displayed value
8.4 Ignition process
•
To ignite the unit, press and hold down the ON
button for several seconds.
•
The message WAIT FLAME will appear in the
display. During this period, the pellets in the
combustion pan are being ignited automatically.
ok Wait/Flame
X
•
After the pellets have been ignited, the message
PRESENT FLAME appears.
•
As soon as the temperature for correct burn-off is
attained, the unit switches to heat operation.
8.5 Heat operation
•
After ignition, the message WORK/MODULING
appears in the display.
ok WORK
P=5 T=55° t=16°/22°
X
•
Heat operation is automatically regulated accord-
ing to the entered settings.
•
The following operation parameters appear in the
display along with WORK:
P = heat setting level
T = Target water temperature in the appliance
t = ACTUAL ROOM TEMPERATURE/TARGET
ROOM TEMPERATURE or
ACTUAL BUFFER
TEMPERATURE/TARGET BUFFER
TEMPERATURE, depending on the
connection type
The display of the operation parameters can be pre-
sented in two different ways, ROLLING or SHORT.
12:45