Makita DUM604 Manuel D'instruction page 8

Indicator lamp
The indicator lamp blinks or lights up when the remain-
ing battery capacity is low or empty. The indicator lamp
also lights up when the tool becomes overloaded.
1
► 1 . Indicator lamp
Lamp status and action to be taken
Indicator lamp
The lamp blinks The remaining bat-
red. tery capacity is low.
The lamp lights up The tool has stopped
red. * because the remain-
ing battery capacity
is empty.
The tool has stopped
due to overload.
* The time at which the indicator lamp lights up varies depending
on the temperature around the work area and the battery car-
tridge conditions.
Adjusting the shearing height (for
grass shear)
CAUTION:
When changing the shearing
height, be sure to attach the blade cover and be
careful not to trap fingers between the tool and
grass receiver.
The shearing height can be set to three levels (15 mm
(9/16"), 20 mm (13/16"), and 25 mm (1")) by changing
the fixed position of the grass receiver. The shearing
height without the grass receiver is about 10 mm (3/8").
1. Slide the grass receiver toward the front of the tool.
► 1 . Grass receiver
Status Action to be taken
Charge the battery.
Charge the battery.
Turn off the tool.
1
2. Change the fixed position of the grass receiver by
moving it in the direction of the arrow.
NOTE: The shearing height value is a guideline. The
actual shearing height may vary depending on the
condition of the lawn or the ground.
NOTE: Try a test shearing in a less conspicuous
place to get your desired height.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves and attach the blade cover so
that your hands and face do not directly contact
the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
8 ENGLISH