Makita DUM604 Manuel D'instruction page 13

Installing shear blades
1. Prepare the crank, undercover, and new shear
blades.
1
► 1 . Crank 2. Undercover 3. Shear blades
2. Attach the blade cover to the shear blades.
3. Adjust the three pins so that they are lined up on
the alignment line.
► 1 . Alignment line
2
3
1
13 ENGLISH
4. Apply a small amount of grease to the periphery of
the crank. Attach the crank to the pins with its small and
large rounds facing down.
► 1 . Crank
5. Slide the shear blades so that the hole on the
base plate is positioned at the center of the rings of
blades.
6. Turn the shear blades upside down and install
them so that the pin on the tool fits in the hole on the
shear blades. Insert the claw of the base plate into the
groove on the tool. Make sure that the shear blades are
fixed securely in place.
► 1 . Claw
1
1