Controls Overview(Fig. B); Getting Started; Prepare The Humidifier - Philips HU4804 Mode D'emploi

Controls overview(fig. b)

Power Turn on or turn off
G
button the humidifier.
Set the timer for the
Timer
H humidifier (1H, 4H,
button
and 8H).
Adjust the fan speed
Fan speed
I (
button
and
Set the relative
Humidity
J humidity level
button
( 40, 50 or 60).
The indicator blinks
Water
when there is not
K level
enough water in the
indication
reservoir.
(low)
,
(normal)).

3 Getting started

Prepare the humidifier

1
Place the humidifier on a flat, stable
surface, about 4 inches (10cm) away
from an inside wall. Make sure the
surface is not sensitive to moisture.
2
Hold by both sides of the upper unit
to lift it up (fig. c).
3
Remove the packaging material of
the new humidification filter (fig d).
4
Assemble the new humidification
filter around the filter support
(fig e).
5
Put the filter and the filter support
back into the water tank (fig f).
6
Fill the reservoir with approximately
67 fl. oz/2000ml cold tap water
until water reaches the maximum
water level indication (fig. g).
7
Place the upper unit back onto the
reservoir (fig. h).
Note
•
DO NOT overfill the reservoir.
•
Always empty the reservoir before
refilling with clean, cold tap water. Rinse
the reservoir, wipe clean and dry with a
clean cloth or paper towel. For complete
cleaning instructions, see section 'Clean
your humidifier'.
EN 7