Denon AVR-1804 Mode D'emploi page 42

ENGLISH
Multi-source playback
[1] Outputting a program source to an amplifier, etc., in a different room (ZONE2 mode)
1
Press the ZONE2/REC button.
The display switches as follows each
time the button is pressed.
2
With "ZONE2 SOURCE" displayed, turn
the FUNCTION knob and select the source
you wish to record.
3
Start playing the source to be output.
• For operating instructions, refer to the manuals of the
respective components.
4
To cancel, turn the function knob and
select "SOURCE".
[2] Remote control unit operations during multi-source playback (selecting the source)
1
Set the slide switch to "AUDIO" and "ZONE2".
2
Press the ZONE2 "ON" button.
To cancel the ZONE2 mode.
Press the ZONE2 "OFF" button.
3
Press the input source button.
• The ZONE2 source switches directly.
4
The output level of the ZONE 2 SPEAKER
OUT terminals can be controlled using the
VOLUME + and - buttons on the remote
control unit.
DEFAULT SETTING (ZONE2 VOLUME LEVEL) :
- - - dB (MINIMUM)
5
When the ZONE2 SOURCE function is set
to TUNER, the preset channel can be
selected using the CHANNEL + and -
buttons on the remote control unit.
(This is only possible when the main unit
in the ZONE2 mode.)
42
(Main unit)
(Main unit)
(Main unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
2, 4 1
Display
PHONO CD TUNER
VCR -1 -2
ZONE2
ZONE2 SOURCE
NOTES:
• The signals of the source selected in the ZONE2 mode are also
output from the VCR-1, VCR-2 and CDR/TAPE recording output
terminals.
• Digital signals are not output to the ZONE2 output jacks.
2
2
3
5
1
1
4
2
2
DVD / VDP TV / DBS
V.AUX CDR / TAPE
(Light)
The main zone output can be
turned on and off with the
"MAIN ON/OFF" button.