Denon AVR-1804 Mode D'emploi page 21

NOTES:
• The AVR-1804/884's on-screen display function is designed for use with high resolution monitor TVs, so it may be difficult to read small
characters on TVs with small screens or low resolutions.
• The setup menu is not displayed when headphones are being used.
• The system setup is not displayed when "HEADPHONE ONLY" is selected.
Before setting up the system
1
(Main unit) (Remote control unit)
2
3
NOTE:
Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time. The changes to the settings made
up to that point are entered.
Check that all the components are correct, then press the POWER operation switch on the main unit or
the POWER button on the remote control unit to turn on the power.
Press the SYSTEM SETUP button to enter the setting.
*SYSTEM SET UP
NOTE: Please make sure the "AUDIO" position of the slide switch
on the remote control unit.
Press the ENTER or (down) button to switch to the speaker configuration set up.
ENGLISH
21