Christopeit Sport Profi Center 9988 Notice De Montage Et D'utilisation page 26

Step 18:
Installation of weight casing (41) with weight casing
support (42) and bending plate 43).
1. Connect the weight casing support (42) and bending plate
(43) at appropriate position of weight casing (41) by using
screw M6x16 (100), washer 6//12 (116) and self locking nut
M 6 (126).
Note, that the weight casing supports (42) and bending
plates (43) have to mount into the right position as showed
in Step 18 drawing.
Step 19:
Installation of weight casing (41) with supports (42+43)
at L-plate (32) and rear foot (2).
1. Put the weight casing (41) with pre-assembled weight
casing support (42) into the holes of rear foot (2). Get the end
of opposite weight casings supports (42) and bending plates
(43) together and screw them tightly by using screw M6x16
(100), washer 6//12 (116) and self locking nut M 6 (126) as
showed in fi gure „A".
2. Put the L-plate (32) under the top cross beam (5) into
appropriate position and screw it tightly by using screw
M8x65 (106), washer 8//16 (117) and self locking nut M 8
(125) as showed in fi gure „B".
3. Connect the upper bending plate connection additionally at
L-plate (32) by using screw M6x16 (100), der Unterlegscheiben
6//12 (116) and der Selbstsichernde Mutter M 6 (126).
Step 20:
Installation of latissimus bar (36) and curl bar (37).
1. Connect the latissimus bar (36) at cable 1 (26) by using
carbine hook (55).
To storage the latissimus bar (36) you can put it on the
appropriate holder in front of the top cross beam (5).
2. Connect the curl bar (37) at cable 4 (31) by using the 22
links chain (54) and carbine hooks (55). (When you use leg
curler for exercising you should take away the curl bar (37)
with chain (54).
3. Depends on exercising you can use the handgrip (72)
instead of latissimus bar (36) or the ankle strap (73) instead
of curl bar (36).
26