Christopeit Sport Profi Center 9988 Notice De Montage Et D'utilisation page 22

Step 7:
Installation of butterfl y arms (11+14) at butterfl y arm
holder (9) and foam rubber roll (63) and hand grips (19).
1. Put the butterfl y shafts (45) into the holder of butterfl y arm
left and right (11+14) and place the butterfl y arms (11+14) in
right position into the appropriate holder of butterfl y holder
(9).
2. Screw the butterfl y arms (11+14) at butterfl y arm holder (9)
tightly by using screw M10x20 (108), spring washer for M10
(122) and washer 10//20 (118) on bottom and top side.
3. Slide the foam rubber roll (63) with help of a little bit soap
water onto the butterfl y arms (11+14).
4. Place the hand grips (19) into appropriate holder of butterfl y
arm left and right (11+14) and screw them tightly by using
screw M8x30 (102), washer 8//16 (117) and spring washer
for M8 (123).
5. For bench press exercising secure the butterfl y arms left
and right (11+14) with locking pins (49) at butterfl y holder
(9) and screw out the handgrip bolt 2 (70) of bench press
support (9).
6. For butterfl y exercising secure the butterfl y arm holder (9)
with hand grip bolt 2 (70) at bench press support (38) und
take out the locking pins (49) from butterfl y arms (11+14).
Step 8:
Installation of the back pad (60) and leg curler holder (12)
at support 2 (7).
1. Adjust the back pad (60) on support 2 (15) so that the
threaded holes in the rear of the back pad (60) are align with
the holes in support 2 (7) and screw it tightly by using screw
M8 x 70 (107), spring washer for M 8 (123) and washer 8//16
(117).
2. Place the leg curler holder (12) in appropriate position at
support 2 (7), so that the holes are align and screw it tightly
by using screw M10x70 (112), adjusting plate (48), washers
10//20 (118) and self locking nut M 10 (124).
Step 9:
Installation of seat pad (17) and round pad holder (18) at
seat support frame (13).
1. Adjust the seat pad (17) on seat support frame (13) so
that the threaded holes in the rear of seat pad (17) are align
with the seat support frame (13) and screw it tightly by using
screw M8 x 45 (104), spring washer for M 8 (123) and washer
8//16 (117).
2. Slide the round pad holder (18) into the seat support frame
(13) in middle position.
3. Slide two black foam rubber roll (64) onto the ends of
round pad holder (18).
22