Publicité
Fig. 1
4
11
12
13
6
14
7
Fig. 2
6
B
7
52
10
8
5
9
3
1
15
2
A
Remaining risks
The machine has been built according to the latest
technology and recognised safety rules. However,
there is still a chance of residual risks whilst work-
ing.
Furthermore, despite all measures taken, remaining
risks can occur that are not obvious.
•
Remaining risks can be minimised by complying with
the „Safety notices" and the „Intended use" as well
as the operating instructions overall.
Unpacking the machine
Check the contents for possible damage during trans-
port.
In the event of damage, this must immediately be re-
ported to the freight forwarder. Check that the contents
are complete.
Immediately report missing parts to the dealer.
Additional parts which need to be attached to the ma-
chine, must be located and allocated before assembly.
Equipment
1 Motor casing with handle
2 Earth auger 100 mm
3 Fuel mixing container
4 Accessories kit/operating instructions
OPERATING ELEMENTS, FIG. 1
1
Motor
2
Fuel mixture tank
3
Air filter
4
Gearbox
5
Carburettor cover
6
Drive shaft
7
Drill
8
Spark plug cap
9
Starter cord
10 Handle
11 Stop switch
12 Safety lock
13 Throttle control lever
14 Throttle adjusting screw
15 Fuel tank cap
Assembly
For packaging reasons, your machine has not been
assembled completely.
Inserting the earth auger, Fig. 2
1
Place the motor casing on a work bench
2
Place the earth auger (7) on the drive shaft (6), en-
suring that both holes are aligned.
3
Insert the driving pin (A).
4
Secure with split pin (B) and slightly bend it.
Publicité
