Publicité
Les langues disponibles
Les langues disponibles
PRODUCT FAMILIARISATION AND INSTALLATION PREPARATION
––– PHASE 2 –––
2.1 - PRODUCT DESCRIPTION AND APPLICATION
This kit consists of a tubular motor and various components, all exclu-
sively designed for automation of roller shutters. Any other use is pro-
hibited! The manufacturer is not liable for damage resulting from
improper use of the product, other than that which is provided for
in this manual.
The tubular motor is formed mainly of a "motor" part, an electronic logic
which supplies the motor and controls execution of manoeuvres, and a
three button control switch, to command the automation system.
The tubular motor, through the use of adapters supplied for the purpose,
is installed by mounting it on the interior of the roller tube and the whole is
then affixed to the inside of the case (located above the roller shutter) us-
ing the supplied components.
The motor has command logic (integrated) with electromechanical limit
switch which halts movement of the roller shutter when the motor reaches
the following positions: the position when it completes the upward move-
ment (maximum opening: in the manual this is called "limit switch 0")
and the position when it completes the downward movement (maximum
closure: in the manual this is called "limit switch 1").
After programming these limit switch positions, sending a command via
the control switch will activate the roller shutter movement, which will stop
automatically when the stored "limit switch" has been reached.
The motor is intended for domestic purposes, not for intensive use. As a
result, in the event of overheating – for instance, due to continued actua-
tion – thermal safety protection automatically intervenes by cutting off the
electrical power supply and subsequently reconnecting it once the tem-
perature returns to normal values. In all cases, a continuous working time
of 4 minutes maximum is ensured.
2
code RM 3017
l
l
code 585.10200
f
f
code 525.10066
code 41.082
i
i
code 515.06000
a
a
n
n
b
g
g
code 525.10012/AX
d
d
2.2 - COMPONENTS CONTAINED IN THE KIT
Important! – Before proceeding with the installation, it is necessary to
check the integrity of the components present in the RMKIT AXS 3017
kit and familiarise yourself with their names. This kit includes the following
components (fig. 2):
[ a ] - Tubular motor (Ø 45 mm): code RM 3017
[ b ] - 60 mm octagonal tube, 1 standard (b1) and 2 telescopic exten-
sions (b2, b3).
[ c ] - Limit switch adjustment key: code 585.10200.
[ d ] - Three button control switch: code 555.30000 (+ 556.10000 +
556.01000).
[ e ] - Roller and its support (Ø 42 mm): code 525.10066 and 41.082
[ f ] - Motor head support with 4 special screws to fix the motor head:
code 525.10012/AX.
[ g ] - Octagonal telescopic cap (60 mm): code 575.12260.
[ h ] - Small metal parts (screws, washers, etc.).
[ i ] - Motor adaptor set for 60 mm octagonal tube: code 515.06000.
[ j ] - Six fasteners for roller shutter.
e
e
b
S T
O P
S T
O P
S T
O P
h
h
code 575.12260
m
m
n
b1
l
b2
b3
f
c
c
i
English – 2
a
g
d
Publicité
