Waterpik WP-250 Mode D'emploi page 13

Toothbrush Tip
Place the toothbrush tip in mouth with the brush head on
the tooth at the gum line. The toothbrush tip can be used
with or without toothpaste. Turn the Water Flosser on
so water flows through the tip. Using a light pressure
(bristles should not bend) massage the brush back and
forth with very short strokes – much like you would with a
manual toothbrush. Repeat on adjacent teeth. Water will
flow through the brush, to help simultaneously clean and
rinse the tooth surface.
Plaque Seeker Tip
®
Direct the jet stream at a 90-degree angle to your gumline.
Close lips slightly to avoid splashing but allow water to flow
freely from mouth into sink. Start in the molar (back teeth)
area working toward the front teeth. Place the tip close to the
teeth so that the bristles are gently touching the teeth.
Gently glide tip along gumline, pausing briefly between
teeth to gently brush and allow the water to flow between
the teeth. Continue until all areas around and between
the teeth both inside and outside, top and bottom have
been cleaned.
Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver
®
mouthwash and antibacterial solutions. Ask your dental
professional to recommend the appropriate solution for
you. Note: use of some antibacterial solutions could
shorten the life of your Waterpik
warnings section for details.
Water Flosser, see
®
13