DeWalt DCP580 Guide D'utilisation page 16

FIG. 11
W
T
S
V
R
U
FIG. 11A
FIG. 12
W
T
S
AA
V
R
Z
FIG. 12A
HIGH-SPEED STEEL BLADE
T U
R
V
W
S
W
FIG. 11B
CARBIDE BLADE
Z
T
R
AA
V
W
S
W
FIG. 12B
14
3. To Reinstall Blade (Fig. 10A, 10B)
a. Cautiously remove the adjusted
guide bar/high-speed steel blade
assembly from the gauge plate (X)
and place the heel of the guide bar
(W) into the groove in the drum (T).
b. Set the drum cover (S) over the
adjusted
V
Y
U
steel blade assembly and securely
tighten the three star head screws
(R) to the drum.
4. Repeat procedure for the other blade.
NOTE: In order to use high-speed steel
X
blades with this planer, the sharpening
FIG. 11C
holder (BB) is required to sharpen high-
speed steel blades and is available at
additional cost from your local D
authorized service center.
REVERSIBLE CARBIDE BLADES
(FIG. 12)
1. To Remove Blade from Planer
(Fig. 12B)
a. Loosen and remove the three star
V W AA Z Y
head screws (R) with the T25 star
key (EE) provided. Remove the
drum cover (S) from the drum (T).
b. Remove the blade carrier/guide bar
assembly (V, W, Z). Carefully remove
X
the carbide blade (Z).
2. To Adjust Blade Using Gauge Plate
FIG. 12C
(provided with tool) (Fig. 12C)
a. Cautiously place the sharp edge of
the carbide blade (Z) on the gauge
guide bar/high-speed
WALT
e