Speedpot Mounting Dimensions; Mounting Instructions; Wiring Procedure - DART Controls 530B CONTROL Série Mode D'emploi

(Control dimensions continued)
3.88
SPEEDPOT
MOUNTING
DIMENSIONS
(For "C" and "RC" versions)
DO NOT MOUNT CONTROL WHERE AMBIENT TEMPERATURE IS OUTSIDE RANGE OF -10° to 45° C. (15° to 115° F.)
1. Four 7/32" slots are provided for control mounting.
2. The 530B Series chassis can be used as a template.
3. Use standard hardware to mount.
4. For the "RE" version ONLY: Two 7/8" diameter holes are provided in one endplate to facilitate wiring. This allows for easy
connection of 1/2" conduit.
NOTE: For enclosed models using 1 h.p. 90V or 2 h.p. 180V motors, the control MUST be mounted vertically.
DO NOT ATTEMPT TO PERFORM HI-POT TEST ACROSS AC LINES WITH THE CONTROL IN CIRCUIT.
THIS WILL RESULT IN IMMEDIATE OR LONG TERM DAMAGE TO THE CONTROL.
1. Size all wires which carry armature or line current to handle currents AS SPECIFIED BY NATIONAL, STATE, AND/OR LOCAL
CODES. All other wires may be # 20AWG or smaller as permitted by local code.
2. Control wire (Pot, Tach, etc.) should be separated from all the Armature, Field (if Shunt Wound), and the AC wires when routed
in conduits or in wire trays. The enclosed version has two holes on one endplate for this purpose.
BOTTOM VIEW
7.50
7/32 DIA.
(4 SLOTS)
9.00
10.00
0.87
SIDE VIEW
CUSTOMER'S MOUNTING BRACKET
.500
1.250
.437
5/32
DIA.
SPEEDPOT LOCATOR HOLE DIMENSIONS

MOUNTING INSTRUCTIONS

CAUTION:

WIRING PROCEDURE

0.20
"RE" SERIES
6.30
HOUSING
6.70
DIMENSIONS
0.50
2.63
1.13
2.13
CUSTOMER'S
MOUNTING BRACKET
DIALPLATE
2.00" dia.
1.240
.370 .370
.250 Dia.
LOCK
SPEEDPOT WASHER
(5K)
3/8
DIA.
4
END VIEW
6.02
4.64
.875 DIA.
2.50
(2 HOLES)
SPEEDPOT
KNOB
HEX NUT
EXPLODED VIEW