ABB DCS 600 MultiDrive Mode D'emploi page 18

Alarm messages (A) Alarm messages are indicated on the seven - segment display of
the SDCS-CON-x processor board or by means of a red LED on the
SDCS-AMC-DC x board. On the seven - segment display the mes-
sages appear in code (Axxx). The letters and numbers of multi -
character codes are displayed one after the other for 0.7 seconds at
a time. Plain text messages are available on the control and display
panel (CDP 31x) and in the fault logger of DriveWindow.
Alarm messages, with the exception of A101 and A102, will not
shut the drive down.
Note The fault and alarm messages are listed in chapter 10.
I 18
taken from/for further information:
Operating instructions
3ADW000080
3ADW000179R0100_DCS600_QuickGuide_edisf_a