Festool CLEANTEX CTM 26 E Notice D'utilisation D'origine page 17

Manual cleaning
Turn the switch [1-11] to the AC symbol.
Full manual cleaning

Cover the end of the nozzle or suction hose with
your hand or closing slide CT-VS (497926) for 2
seconds.

Turn the switch [1-11] to the AC symbol.
8.3 Special features of the CTM 36 E AC- LHS
To use the mobile dust extractor in combination with
the PLANEX:

Use kink-resistant suction hose D 36 mm x 3.5 m-
AS.

Use a special suction sleeve for connecting the
PLANEX.

Use closing slide CT-VS between the intake open-
ing [1-2] and suction hose.

Attach the tool holder.

Always use with a disposal bag!
8.4 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage

Use a filter or disposal bag when extracting haz-
ardous materials!

Do not use the machine if the volumetric flow
monitoring function is inactive.
Observe the following when extracting dust generat-
ed by operating electric power tools:
If the exhaust air is discharged back into the room,
the air renewal rate L within the room must be suf-
ficient. The volume of air discharged back into the
room must not exceed 50% of the fresh air volume
flow (room volume V x air renewal rate L
R
all the relevant regional regulations.
Remember: A moist main filter clogs more quickly
when extracting dry materials. Therefore, dry the
main filter before extracting dust or replace the
damp filter with a dry one.
8.5 Extracting wet materials/liquids
Remove the filter or disposal bag!
Recommendation: use special wet filter (NF-
CT).
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
Escaping foam and fluids

Switch off and empty the machine immediately.
8.6

Only versions with AutoClean: Clean the main fil-
ter automatically or manually (see chapter 8.2).

Switch off the mobile dust extractor and pull out
the mains plug.

Wind up the mains power cable.

Empty the dirt trap.

Close off the extractor opening [1-2] using the
sealing plug [1-1].
Hazardous dust
Damage to the respiratory passage

Wipe down the mobile dust extractor and clean
all accessories thoroughly using the extractor
(inside and out) before removing from the work-
ing area.

Parts that you were not able to clean thoroughly
must be sealed in an airtight plastic bag prior to
transportation.

Wear a dust mask!
The machine shall be stored indoors only.

Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
9
). Observe
W
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
CAUTION
After finishing work
WARNING
Service and maintenance
WARNING
Customer service and repair only
through manufacturer or service work-
shops: Please find the nearest address
at:
www.festool.com/Service
CTM
GB
17