Festool CLEANTEX CTM 26 E Notice D'utilisation D'origine page 16

CTM
GB
7.6 Temperature cut-out
A temperature cut-out switches the mobile dust ex-
tractor off when it reaches a critical temperature to
prevent overheating.

Switch off the mobile dust extractor, allow to cool
for about 5 minutes then switch on again.
 Not possible to switch on: contact Festool service
workshop.
7.7 Changing the filter bag (SC FIS-CT 26/36/
48)
Removing the filter bag [4]

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Remove the filter bag.

Dispose of the used filter bag in accordance with
statutory regulations.

Clean the dust container [2-3].
Inserting the filter bag [5]

Insert a new filter bag (SC FIS-CT 26/36/48) in the
inlet port of the dust container and interlock it.
Important: be aware that the locking engages.

Replace the top section [2-1] and close the lock-
ing clips [2-2].
 Make sure that the filter bag is not pinched be-
tween the top and bottom sections.
7.9 Volumetric flow monitoring
An acoustic warning signal sounds if the air speed in the suction hose falls below 20 m/s.
Possible causes
Value set on the suction power adjuster [1-10] is
too low.
Rotary knob [1-9] not set to the correct hose
diameter.
Suction hose blocked or kinked.
Filter bag full.
Filter element clogged.
Monitoring electronics malfunction.
Wet extraction.
8 Working
8.1 Handling
Hose store: after finishing work, you can feed the
suction hose through the recess [8-3] and place it in
the hose store. You can do the same with the mains
cable through the other recess [8-2].
SysDoc Systainer attachment system: a Systainer
can be attached to the storage area via the two slides
[8-1].
16
7.8 Changing the disposal bag
Removing the disposal bag [6]

Close off the extractor opening [1-2] using the
sealing plug [1-1].

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Close the disposal bag.

Remove the disposal bag.

Dispose of the used disposal bag in accordance
with statutory regulations.

Clean the dust container [2-3].
Inserting the disposal bag [7]

Insert a new disposal bag (ENS-CT26/36/48) on
the inlet nozzle of the container and lock in posi-
tion.
Important: The lateral openings on the disposal
bag must be positioned inside the container.
Make sure that the bolt engages.

Place the disposal bag over the edge of the con-
tainer.
Make sure that the contacts [10-2] are free.

Replace the top section [2-1] and close the lock-
ing clips [2-2].
Solution
Set the suction power adjuster to a higher value (see
Chapter 7.4).
Set the knob to the correct hose diameter (see Chap-
ter 7.1).
Remove blockage or kink.
Insert a new filter bag (see Chapter 7.7).
Change the filter element (see Chapter 9.1).
Only AUTOClean: Clean filter element (see chapter 8.2).
Send to a Festool service workshop for repair.
Functional reliability not affected, no actions required.
8.2 AUTOClean - Cleaning the main filter (only
versions with AutoClean)
Only in conjunction with disposal bag (com-
pliance with dust class 'M'). Not suitable for
wet extraction!
Automatic cleaning
Adjust the frequency using the rotary knob [1-8].