Maintenance Procedures; Changing The Application Tip; Refilling The Metering Medium; Thickening The Metering Medium - Ecolab MULTILINE 1000 Manuel D'utilisation

Maintenance procedures

8 Maintenance procedures
Personnel:
8.1

Changing the application tip

The application tip must remain on the metering valve at all times.
When changing the tip, hold the applicator head with the tip facing up, pull the tip off and
replace with a new tip.
The new tip should then be filled by the transmission of short pulses to the unit.
8.2

Refilling the metering medium

To prevent any malfunctions as a result of air bubbles in the ducting system, the
MULTILINE 1000 applicator unit is fitted with an empty signal device and a reserve signal.
When the critical minimum quantity in the pressure tank has been reached, a signal is
displayed, indicating that a refilling of the metering medium is necessary.
To do this, use the pressure control valve to vent the pressure tank, screw off the cover
and insert the new bottle, or refill the plastic insert.
When putting on the cover make sure that the toroidal sealing ring is seated neatly in the
groove provided.
8.3

Thickening the metering medium

Should the metering medium start to thicken, even though the unit is being used properly,
the applicator head is to be freed from polymerised glue by continuously applying and
increasing the static pressure.
CAUTION!
Do not remove the applicator head under any circumstances.
417101357 Rev. 3-05.2019
n Specialist
n Qualified electrician
n Mechanic
n Service personnel
26