Dometic 935000.140 Instructions D'installation Et D'utilisation page 9

INSTALLATION INSTRUCTIONS
22. Make sure the RV entrance steps are in the
extended or down position.
 If the RV is equipped with an
automatic entry step, make sure the automatic
operation is disabled. Make sure this step
remains in the "down" or "extended" position
while installing and using the product.
23. The vehicle skirting (25) is one piece of fabric
300" long. The skirt is to be cut to fit the Veranda
Room on which it is installed. The twist fasteners
(26) for the skirt need to be screwed into a solid
structure that is 1 to 2" from the bottom of the
RV wall. The skirt must extend past the end
of the right and left side panels (27) 3 to 4".
See FIG. 14.
FIG. 14
28
24. Drill a 1/8" pilot hole for the twist fastener at the
right/left corner of the Veranda Room. Mark the
opposite end of the fabric to be trimmed 3 to 4"
past the end of the Veranda Room. Square and
cut off. Pull the vehicle skirt (25) taut and finish
installing the twist fasteners (reference Step 20)
in a straight line along the bottom of the RV. The
remaining corner (if eyelet is cut off when skirt
is cut to length) is held in place by attaching the
1x3" hook and loop fasteners (28) supplied in
the kits. See FIG. 14.
 Skirting MUST not interfere with
appliance venting. Do NOT start or operate the
RV engine or RV generator if exhaust vents are
located behind skirting. Death or serious injury
from Carbon Monoxide Poisoning could occur if
NOT operated properly.
27
29
26
25
25. Locate the step and determine the uppermost
part (30) of it by feeling. Mark the edges of the
step on each side (31). See FIG. 15.
FIG. 15
32
30
26. Measure down from the top edge of the skirt to
the lowest part of the step (32). Add 1/4" to this
measurement. Mark a line for the cut for the step
on the skirt fabric. See FIG. 15.
27. Draw three lines (33) for the step flap on the
skirt fabric and cut with scissors or a utility knife.
See FIG. 16.
FIG. 16
Skirt Top
Measure
Down From
Top Of Skirt
To Lowest
Part Of Step
28. Tuck the flap of the skirt behind the step to keep
out insects.
29. The wheel well skirts (29) are installed in the
same way as the main skirt. They are centered
on the wheel well. Peel the backing of the hook
and loop fasteners (28) and attach to the RV.
Two skirts are provided with the Veranda Room
door and side panel assembly. Both are used on
dual axles. Triple axles will require three wheel
well skirts. Order additional wheel well skirt part
number 3307975.007. See FIG. 14.
9
31
Marks For The Top And
Widest Part Of Step
33