Dometic 935000.140 Instructions D'installation Et D'utilisation page 7

INSTALLATION INSTRUCTIONS
5. Release the adjustment clamp (35) on the
vertical pole (34) and extend the pole until it
reaches the roller tube clamp (8). Insert the
metal pin (36) on the end of the vertical pole (34)
into the bottom hole of the roller tube clamp (8).
FIG. 6
36
6. There is a 3/16" diameter poly rope sewn into
the top edge of the front panels (4). The front
panels (4) are to be hung from the roller tube
(5) by inserting the poly rope into the accessory
channel (6) in the left hand end cap (7) and
sliding it the entire length of the roller tube (5).
See FIG. 5. Make sure this accessory channel
(6) faces as shown in FIG. 3.
7. Zip the door and panels together to make the
front screen assembly. The door can be installed
on either end of the front or between panels.
8. While one person pulls on the leading edge of
the front assembly, a second person feeds and
guides the front panels (4) into the accessory
channel (6). The installer can spray the accessory
channel with a dry PTFE spray lubricant to make
this operation easier. See FIG. 5.
9. Install the second roller tube clamp (8) by aligning
the roller tube insert (9) with the accessory
channel (6) of the left hand end cap (7). Depress
the spring button (10) to slide up to the edge of
the front panels (4). See FIG. 3, FIG. 4, & FIG. 5.
10. Repeat the procedure in Step 5 for the vertical
pole (34) on the opposite end.
11. For the full width Veranda Room, place the front
panel as assembled so that it is centered in
relationship to the front of the awning.
 A smaller Veranda Room used with a larger
awning may be located in a similar fashion
as long as the zipper at each end of the
front panel is used as a guide to locate the
roller tube clamp (8). See FIG. 3.
12. Measure the horizontal distance from the edge
of the awning fabric (11) to the center of the
top hole in the roller tube clamp. This is the
dimension for the location of the pole holder
(12). See FIG. 7.
8
34
35
FIG. 7
12
15
13. Below the awning rail, measure and mark the
same dimension on the side of the RV below the
awning rail as measured in Step 12. Place the
pole holder (12) directly below the awning rail
(13) on the line and mark its center point. Use a
1/8" drill bit to make a pilot hole (14). See FIG. 7.
14. Apply silicone sealant to the screw (15) threads
and secure the pole holder (12) to the side wall
of the RV. See FIG. 7. Repeat Step 12 through
Step 14 for the opposite side.
15. The rafter poles (16) are in two pieces for easy
storage when not in use. Assemble the rafter
by inserting the pole with the metal pin (17) into
the pole with the rubber tip (18). Make sure the
metal pin (17) is visible. See FIG. 8.
FIG. 8
16
17
16. Slide the rafter pole (19) assembly through one
of the three pockets on the top edge of the side
panels (20). The top pocket is for most vehicles
with the awning high enough to be sloped
down. The middle and lower pocket are used on
RVs that need the awning to be relatively flat.
See FIG. 9.
 W hen the awning is relatively flat and the
screen room pole is in the lowest position,
roll-up the awning if rain is anticipated to
prevent damages.
7
14 13
11
18