Surface Operation - Wolf DF304 Guide D'utilisation Et D'entretien

SURFACE OPERATION

Oven Light
WARNING
Verify power is disconnected from the electrical box
before replacing a light bulb.
Allow the oven to cool completely, then remove oven racks
and rack guides. To remove the light cover, gently pry the
bottom edge with a flat screwdriver. Remove the existing
bulb and replace with a 20-watt halogen bulb. Refer to the
illustration below.
LIGHT
COVER
Light bulb replacement.
|
16 Wolf Customer Care 800.222.7820
Surface Burners
To light a burner, push and turn the corresponding control
knob counterclockwise to HI. The igniter will begin to click
until the burner is lit. Once lit, continue to turn the knob
counterclockwise to desired setting.
To select a simmer setting, turn the control knob to the
detent at the lowest setting. Push and continue to turn
counterclockwise. The flame will transition to the second
tier on the burner cap. Continue to turn the knob to desired
simmer setting.
During a power outage, surface burners can be lit manually.
Turn the knob to HI and light using a multi-purpose lighter.
CAUTION
Never leave pans on a high setting unattended. Be
careful when cooking food in fat or grease; it can
become hot enough to ignite.