Hach 6792200 Manuel D'utilisation page 7

Figure 5 Electrical access ports
1 Power in (power cord only), no
ground plate. Do not use for
conduit.
2 Communication and network
modules (3x)
3 Communication and network
modules (8x)
4 Power in or out (conduit or power
cord), ground plate, communication
and network modules (8x)
Remove the access cover
Remove the access cover to connect to the wiring terminals. Refer to
Figure 6.
Figure 6 Access cover removal
Connect optional devices
Install the cables for output or input devices as shown in
sure to use the wire gauge that is specified for the connection. Refer to
Specifications on page 3. To configure a device, refer to the operations
manual.
Figure 7. Make
English 7