Publicité
Les langues disponibles
Les langues disponibles
• The weather station stores new minimum and maximum values from the reset point.
f) HI/LO alarm setting
You can use the target temperature or the target air humidity (HI/LO) to configure multiple
temperature and air humidity alarms for indoor and outdoor use. Depending on the number of
outdoor sensors used, up to 8 alarms can be set for outdoor and for indoors.
• Press and hold the MODE ALERT button (3) for 2 seconds to access alarm settings mode.
The symbol for the indoor displayIN towards the bottom of the LCD display (1) will flash.
• Press the Channel + button (2) or the - MEM button (4) to select the channel to be set. The
channel symbol for the active channel will flash. You are now able to set the active channel.
• Press the MODE ALERT button (3) to toggle between setting the target values selected for
temperature and air humidity for the active channel. The first active setting value is the upper
alarm limit
for temperature. This value flashes when ready for setting.
• Briefly press the Channel + button (2) or the - MEM button (4) several times, to increase or
decrease the value for the upper alarm limit by tenths (0.1 °C or °F). Pressing and holding
means that the device scrolls through the settings more quickly.
• Press the MODE ALERT button (3) twice to switch to setting the lower alarm limit
temperature. This value flashes when ready for setting.
• Briefly press the Channel + button (2) or the - MEM button (4) several times, to increase or
decrease the value for the lower alarm limit by tenths (0.1 °C or °F). Pressing and holding
means that the device scrolls through the settings more quickly.
• Press the MODE ALERT button (3) three times to switch to setting the upper alarm limit
for air humidity.
• Press the MODE ALERT button (3) four times to switch to setting the lower alarm limit
for air humidity.
• If you briefly press the Channel + button (2) or the - MEM button (4) for both setting
values several times, you can increase or decrease the value for the target air humidity
by hundredths i.e. by 1 %. Pressing and holding means that the device scrolls through the
settings more quickly.
The setting range for the temperature alarm is between -40 °C and +80 °C. The
setting range for the air humidity alarm is between 1 % and 99 %. It is not possible
to configure alternative settings. If, for example, the HI-value is set at 40 °C or %, it
is only possible to set a LO-value of max. 39.9 °C or 39.9 %. There must be at least
one adjustment step between Hi and Lo Alarm values.
• Press the MODE ALERT button (3), in order to activate or deactivate an alarm set. If the
symbol is displayed, the corresponding alarm is activated. If the symbol disappears , the
alarm is deactivated.
• Repeat the process for setting all further channels. The setting sequence is always: →
Temperature
→ Temperature
• To reset alarms set to their initial position, press the RESET button (13) or temporarily
remove the batteries from the weather station.
g) Turning off the temperature or air humidity alarm
• When an alarm is triggered, an audible alarm sounds and the alarm symbol (
• Press the LIGHT button (14) to turn off an alarm.
• The triggered alarm ends automatically after 2 minutes if no buttons are pressed during this
time.
h) Automatic display cycle
• If the weather station is in normal mode, press and hold the Channel + button (2) for
2 seconds to switch on the automatic display cycle. A short beep will sound and the symbol
appears in the LCD display (1).
• The display in the bottom line of the LCD display (1) will now alternate between indicating
indoor values IN and values from the active outdoor sensors from channel number 4 and
above, in a 4-second rhythm. The values of the outdoor sensors of the first three channels
will continue to be indicated in lines 1 to 3, where these are available.
• If all channel numbers from 4 to 8 are deployed, indoor values and all values from the sensors
will be indicated in their natural sequence, each displaying for 4 seconds. The cycle repeats
in the same sequence until the automatic display cycle is turned off again.
• If no values (radio signal) are available for a channel, none will display.
• To turn off the automatic display cycle, press and hold the Channel + button (2) for
2 seconds. The
symbol will disappear from the LCD display (1). The automatic display
cycle terminates.
→ Air humidity
→ Air humidity
Care and Cleaning
• Always disconnect the product from the power supply before cleaning it.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may
damage the housing or cause the product to malfunction.
• Use a dry, lint-free cloth to clean the product.
Declaration of Conformity (DOC)
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declares that this
product conforms to Directive 2014/53/EU.
Click on the following link to read the full text of the EU Declaration of Conformity:
www.conrad.com/downloads
Select a language by clicking on the corresponding flag symbol, and then enter
the product order number in the search box. The EU Declaration of Conformity is
available for download in PDF format.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from
the product.
b) (Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used
for
batteries/rechargeable batteries. Disposing of them in the household waste is
prohibited.
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that
disposal in the domestic waste is forbidden. The designations for the heavy metals
involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable)
batteries, e.g. below the trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
a) Weather Station
Power supply ........................................4 x 1.5 V/DC AA batteries (not included)
Transmission frequency........................433 MHz
Reception range ...................................maximum 30 m
Operating conditions ............................. -5 to +50 °C, 10 - 90 %
Storage conditions ................................ -20 to +60 °C, 10 - 80 %
Dimensions (W x H x D) .......................130 x 112 x 275 mm
Weight ..................................................217 g (without batteries)
Total weight ...........................................471 g
b) Outdoor sensors
Power supply ........................................2 x 1.5 V/DC AA batteries (not included)
Battery life .............................................about 15 months
or
) flashes.
Protection rating ...................................IPX3
Transmission frequency........................433 MHz
Transmission range ..............................maximum 30 m
Transmission power..............................7 dBm (antenna)
Operating conditions ............................. -40 to +60 °C, 1 - 99 %
Storage conditions ................................ -20 to +60 °C, 10 - 80 %
Dimensions (W x H x D) .......................61 x 113 x 395 mm
Weight ..................................................81 g (sensor without batteries)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval of the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
relative humidity (non-condensing)
relative humidity (non-condensing)
relative humidity (non-condensing)
relative humidity (non-condensing)
*1719613_v1_1218_02_DS_m_4L_(1)
Publicité
