Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Programming and Calibration
Using the SetEvent Menu
The second event screen lets users specify what will trigger an event. The
screen displays ALRA (the default value).
•
Press enter to enable the field and use the arrows to scroll through
the options:
= ALRA: (through ALRC) Links the event to Alarm A, B or C
= Fault:
Links the event to a fault condition
= ALL:
Links the event to all conditions (alarm and fault)
= ---:
Displays the EraseALL screen. When "Yes?" is
selected from the Event #1 menu, all configuration
data for events will be erased.
Note that when "---" is selected at any other event number, the
EraseALL screen does not appear and the data for the active
event number will be erased (and events will change numbers,
moving up one).
When you have selected the option and pressed enter, the field is
disabled and you can proceed to the next screen. Use the arrows to
move ahead one screen.
38
If ManSW#1(or #2) was selected at the previous step this
screen will only have 2 options: Open or Closed.
Set to Open if the output is set to Normally Closed, or to
Closed if the output is set Normally Open.
301EM User Manual
Event# 1
= ALRA
EraseALL
No?
Publicité
Chapitres
Table des Matières
