Changing Event Configurations - Honeywell 301EM Mode D'emploi

Changing Event Configurations

The various event menus allow users to modify standard configurations or
to create completely customized event configurations, based on their
needs. Each event menu provides a set of four options, which also
contain a subset of options, as described below.
The first screen that appears is the main event screen. Press enter to
select the event displayed or use the arrows to scroll through the event
numbers to select a specific event.
The first event screen lets users specify which sensors will be linked to
the event. The screen displays SD All (the default value). Press enter to
enable the field and use the arrows to scroll through the available options.
When the desired option is displayed press enter to select.
SD All: Applies the event action to all sensors
SD #1: (through SD #4) Applies the event action to only the selected
sensor
ManSW#1: (through ManSW#2) Applies the event action to the selected
switch
SD #---: Displays the EraseALL screen. When "Yes?" is
selected from the Event #1 menu, all
configuration data for events will be erased.
Note that when "SD #---" is selected at any other event
number, the EraseALL screen does not appear and only the
data for the active event number will be erased (and events
will change numbers, moving up one).
When you have selected the option and pressed enter, the field is
disabled and you can proceed to the next screen. Use the arrows to
move ahead one screen.
Type1CND
Event# 1
Event# 1
SD All
301EM User Manual
Programming and Calibration
Using the SetEvent Menu
EraseALL
No?
37