Programming The Unit - Honeywell 301EM Mode D'emploi

Programming the Unit

The 301EM is equipped with a programming menu that allows users to
modify certain parameters and to calibrate the unit.
Menu Option
Password
Set Adr.
Mem SD
Sensor
Set #RP
Service
SetEvent
SetRelay
Buzzer
Set Alr
SetAnOut
Set Zero
Set Span
Quit
Provides password restricted access to programming
menus
Lets users select a specific address for the device
Inactive option: Reserved for technicians' use only
Lets users add or remove a sensor
Lets users add up to ten 301EMRP units
Lets users specify different Service alarm settings
Lets users configure specific events for some or all sensor
types
Lets users specify whether a relay will be set to failsafe
Lets users activate or deactivate the silence button
Lets users set specific minimum and maximum alarm levels
(for alarms A, B and C)
Lets users adjust the 4-20 outputs
Lets users adjust the sensor zero
Lets users calibrate each sensor
Lets users exit the programming menus
301EM User Manual
Programming and Calibration
Description
Programming the Unit
29