DeWalt DC352 Mode D'emploi page 41

• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their respective
points in the plug (see below). Brown is for Live
(L) (2) and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminals crews.
4
3
WARNING: NEVER use a light socket.
NEVER connect the live (L) or
neutral (N) wires to the earth
pin marked E or
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm ; the maximum length is 30 m.
2
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and removing the
battery pack from the tool (fi g. 2)
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
1. Insert the battery pack (n) into the grip until it
2. To remove the battery pack, press the two
Bevel adjustment (fi g. 1)
The bevel angle can be adjusted between 0° and
47°.
1. Loosen the bevel adjustment knobs (e).
2. Set the bevel angle by tilting the saw shoe (d)
1
3. Tighten the bevel adjustment knobs (e).
2
Changing the saw blade (fi g. 4, 5)
1. Press the lock button (l).
2. Press the plunge saw down to stop (blade
3. Turn the lock lever (m) clockwise until it stops.
4. Press the lock lever (m) down and rotate the
NOTE: The blade (k) is now locked and cannot be
turned by hand.
.
5. Turn the blade clamping screw (r) anti-clockwise
6 Remove the outer flange (s) and used blade (k).
7. Replace the outer flange (s) and blade clamping
NOTE: The direction of rotation of the saw blade
and the rotation of the plunge saw MUST be the
same.
8. Tighten the blade clamping screw firmly using
9. Turn the lock lever (m) anti-clockwise until it
WALT battery
E
10. Move the plunge saw back to top position.
11. Push plunge trigger (a) forward, to lock saw
Adjusting the riving knife (fi g. 5)
For the correct adjustment of the riving knife (u), refer
to the figure 3. Adjust the clearance of the riving
installing and removing accessories,
before adjusting or changing set-ups
or when making repairs. Be sure the
trigger switch is in the OFF position. An
accidental start-up can cause injury.
clicks in place.
release buttons (q) simultaneously and pull the
pack out of the grip.
until the mark indicates the desired angle on
the depth scale (g).
change position).
blade until the lock position is found.
to remove.
Place the new blade on the inner flange (t).
screw (r). Turn the screw clockwise by hand.
the Allen key.
stops.
blade change.
EN GL IS H
37