DeWalt DC352 Mode D'emploi page 40

EN GLI SH
If the battery pack is left in the charger after the initial
1-hour charge, the charger will automatically initiate
the refresh mode. This mode will continue up to 8
hours, but the battery pack can be removed at any
time during the refresh mode.
Hot/Cold Pack Delay
When the charger detects a battery pack that is
too hot or too cold, it automatically starts a Hot/
Cold Pack Delay, suspending charging until the
battery has reached an appropriate temperature.
The charger then automatically switches to the pack
charging mode. This feature ensures maximum
battery life. The red indicator blinks long, then short
while in the Hot/Cold Pack Delay mode.
Package contents
The package contains:
1 Plunge saw
1 Allen key
2 Battery packs (DC352KB)
1 Charger (DC352KB)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1–4)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
INTENDED USE
The DC352 plunge saw is designed for professional
sawing applications and cutting wood products.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This heavy-duty plunge saw is a professional power
tool. DO NOT let children come into contact with
the tool. Supervision is required when inexperienced
operators use this tool.
a. plunge trigger
b. on/off switch
c. main handle
d. shoe
e. bevel adjustment knob
f. depth adjustment knobs
36
g. depth scale
h. front handle
i. dust extraction outlet
j. rail adjuster
k. blade
l. lock button
m. lock lever
n. battery pack
o. charger
p. battery cap
q. battery release button
r. blade clamping screw
s. outer flange
t. inner flange
u. riving knife
v. riving knife screw
w. cutting indicator
x. anti-kickback knob
y. outer guard
z. guide rail
aa. clamp
bb. blade position indicators
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains plug replacement
(U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.