Wiring; Can Bus Interface; Culus - IFM DTC600 Notice De Montage

Cover the unused sockets with protective caps (E73004).
Tightening torque 0.6...0.8 Nm.
Accessories: www.ifm.com

6.1 Wiring

1
Fig. 8: Wiring

6.2 CAN bus interface

The device has a CAN interface.
Use cables that are approved for CAN bus. Terminate the cables using
terminating resistors (120 Ω). Use ifm's EVC492 cable with integrated
terminating resistor as an alternative.

6.3 cULus

For devices with cULus approval and the cULus scope of validity:
► Supply the device from an isolating transformer having a secondary UL- listed
fuse rated:
a) 5 A at voltages of 0...20 V rms (0...28.3 V p )
b) 100/V p at voltages of 20...30 V rms (28.3...42.4 V p )
(1) Power supply and CAN bus
M12 connector, A-coded, 5 poles
1 CAN screen
2 U+
2 1
3 CAN_GND
5
4 CAN_H
3 4
5 CAN_L
Not used
Supply voltage
GND
H bus cable
L bus cable
UK
11