Assembly; Assemble The Operator (Models T And Gt) - LiftMaster Elite Série Manuel D'installation

ASSEMBLY

ASSEMBLE THE OPERATOR (MODELS T AND GT)

NOTE: For Model APT assembly refer to page 9.
1
Install the track spacers evenly over the length of the track.
Fasten the spacers to the track with bolt (A) and fl ange hex
nuts (B).
SPACERS PROVIDED
2
3
4
2
Install the front idler to the track with bolts (F) and washers (D).
3
Assemble the trolley with the take up bolt (C), hex nuts (E),
and lock washer (D).
4
Slide the trolley onto the track.
5
Insert bolts (A) into the end of the track and loosely thread the
nuts (B) onto the ends of the bolts.
6
Slide bolts (A) on the end of the track assembly into the "L" slot
in the operator and tighten nuts (B). Insert bolts (A) into the
holes on the end of the track and the operator. Secure the track
with nuts (B).
TRACK LENGTH
8-14 Foot
16-20 Foot
22-24 Foot
1
5
6
A
Bolt 3/8"-16 x 3/4"
C
D
Lock Washer 3/8"
F
3
7
HARDWARE
B
Flange Hex Nut
3/8"-16
Take Up Bolt
E
Hex Nut 3/8"-16
Bolt 3/8"-16 x 1"
2
4
Assembly - Trolley