Hitachi DS 18DBL2 Instructions De Sécurité Et Mode D'emploi page 16

English
The L-side of the selector button is pushed to
turn the bit counterclockwise (See Fig. 13).
(The and marks are provided on the body.)
Trigger switch
marks
CAUTION
The push button can not be switched while the
power tool is turning. To switch the push button,
stop the power tool, then set the push button.
5. Change rotation speed.
Work
Brick
(DV18DBL2)
Wood
Drilling
Steel
Aluminum
Small screw
Screw tightening
Wood screw
7. Confi rm the clutch dial position (See Fig. 16).
<DS18DBL2>
The tightening torque of this unit can be adjusted
according to the clutch dial position, at which the
clutch dial is set.
16
Selector button
marks
Fig. 13
Low speed
Shift knob
Fig. 14
Cap position
1 – 22
1 –
Operate the shift knob to change the rotational speed.
Move the shift knob in the direction of the arrow (See
Figs. 14 and 15).
When the shift knob is set to "LOW", the drill rotates at
a low speed. When set to "HIGH", the drill rotates at a
high speed.
CAUTION
● When changing the rotational speed with the
shift knob, confi rm that the switch is off .
Changing the speed while the motor is rotating
will damage the gears.
● When a large force is required for operation
(operations indicated in the following chart) set
the shift knob to "LOW". If "HIGH" is set and the
unit is used, it may cause the motor to burn out
or malfunction prematurely.
6. The scope and suggestions for uses
The usable scope for various types of work based
on the mechanical structure of this unit is shown in
Table 8.
Table 8
Use for drilling purpose.
Use for drilling purpose.
Use the bit and socket matching the screw diameter.
Use after drilling a pilot hole.
High speed
Shift knob
Fig. 15
Suggestions