Electrical Connection; Initial Operation - Graef SLICED KITCHEN SKS 850 Mode D'emploi

cially at risk.
• For this reason never reach into
the space between the stop plate
and blade as long as the stop
plate is not completely closed, i.e.
set to (below „0").

ELECTRICAL CONNECTION

For safe and fault-free operation of the
unit, the following requirements have to
be met during the electrical connection:
• Before connecting the unit, compare
the connecting data (voltage and fre-
quency) on the type plate with those
of your energy network. These details
must correspond so that no damage
occurs to the unit. In case of doubt
ask your trained electrician.
• The socket has to be protected at
least by a 10 amps circuit breaker.
• Make sure that the power cable is
not damaged and is not laid across
hot surfaces or sharp edges.
• The connecting cable must not be
stretched tightly.
• The electric safety of the unit is
ensured only when it is connected to
a socket with protective conductor
installed correctly. Operation on a
socket without protective conductor
is forbidden. If in doubt, let the house
installation checked by a trained
electrician. The manufacturer shall
not assume responsibility for damage
which has been caused by absent or
interrupted protective conductor.
PRIOR TO FIRST USE
Prior to first use, use a moist cloth to
wipe the blade of the machine in order
to remove any production residue. See
cleaning.
CAUTION!
• Sharp blade!
• Proceed with caution when wip-
ing the blade.
TRIGGER GUARD
This device has been provided with a
trigger guard as a protection against un-
authorised use. The trigger guard fitted
below the carriage is pressed in direction
of the power button without pressure
on the safety switch button. The device
can be switched on only when released.

INITIAL OPERATION

CAUTION!
Observe the following safety in-
structions to prevent hazards and
material damage:
• Do not touch the blade with your
fingers. This is very sharp and can
cause several injuries.
• The rotating blade can cut off
body parts.
• Your fingers are at risk, especially
your thumb.
• Check whether the blade cover
plate is attached to the machine
properly.
USE OF THE SLICER
IMPORTANT!
The unit must not be used without
the end-piece holder, unless the size
and shape of the slicing material
permits.
CAUTION!
Sharp blade!
• Insert the plug into the socket.
• Place the slicing material on to the
slide.
DE
EN
FR
NL
IT
ES
DK
17