Toshiba MMK-AP0073H Mode D'emploi page 6

Masquer les pouces Voir aussi pour MMK-AP0073H:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
SMMS High-Wall Type
Names and functions of
indicators and controls on
indoor unit
Display panel
3
The operating conditions are indicated below.
1
OPERATION (Green)
This lamp goes on during operation.
2
TIMER (Green)
This lamp goes on white the timer reserved.
NOTE
In case of timer setting by wired remote controller,
TIMER lamp does not light.
In case of group control, TIMER lamp goes on
header unit only. (see "6 LIMITED OPERATION
BY GROUP CONTROL")
3
Preheat/Defrost (Orange)
This lamp lights up when the power is turned on or
right after heating operation starts or during defrost
operation.
5-EN
2
1
4
• Disagreement in operation mode
If you select AUTOMATIC OPERATION in a
model with no auto-changeover (cooling/
heating) control setting or if you select HEAT in
a Cool Only model, an alarm sound (pi, pi) from
the air conditioner due to disagreement in
operation mode. Change the operation mode
with the MODE button on the wireless remote
controller. This disagreement indication cannot
be deleted by the wired remote controller.
• When local prohibition is set by the central
control from other equipment, no signal is
received even if the remote controller button is
pressed. However, a signal of START/STOP
button is accepted. (An alarm sound "pi " arises
intermittently five times.)
4
TEMPORARY operation
If you misplace or lose the wireless remote controller
or its batteries are exhausted, push the
• Push the
button to start the air conditioner.
Push this button once again to stop it.
– 5 –
Owner's Manual
CAUTION
button.

Publicité

Table des Matières
loading

Table des Matières