Technical Characteristics; Technical Specifications - Baier BDB 825 Mode D'emploi

3

Technical Characteristics

3.1

Technical specifications

Diamond drill type
Manufacturer
Operating voltage (V / Hz)
Power consumption (watt)
Protection class
No-load speed (min -1 )
Impact frequency (imp)
Core drill bit diameter (mm)
Bit holder
Weight (kg) 1)
Speed electronics
Sound measurement 2)
L (sound pressure) dB (A)
pA
L (sound power) dB (A)
WA
Vibration measurement (m/s
Rear handle (5) 1
Weight according to EPTA procedure 01/2003.
1)
2) Measured values for noise determined according to EN 60745. Wear hearing protection!
3) Total vibration values (vector sum in three directions) determined according to EN 60745
The vibration emission values given in this instruction manual have been measured according to a method
of measurement standardised in EN 60745 and can be used for comparison between power tools. They
are also suitable for a preliminary estimate of the vibratory stresses.
The vibration emission values given represent the main applications of the power tool. If the power tool is
used for other applications, with different insert tools or are insufficiently serviced, this can significantly
increase the vibratory stresses over the whole work period. For a precise estimate of the vibration
emission values, the times during which the tool is switched off or is running but not actually in use should
also be taken into account. This can reduce the vibration stresses over the whole work period significantly.
WARNING
Health risk due to vibrations.
Î Additional safety measures should be taken
to protect the user, e.g. wearing anti-vibration
protective gloves, correct maintenance
of power tools and insert tools, keeping
hands warm and good organisation of work
sequences.
K = 3 dB
2 ) 3) K = 1.5 m / s
2
m / s
Maschinenfabrik OTTO BAIER GmbH
~230 / 50 / 60
1¼ UNC and G½
2
BDB 825
1800
/ I
1800
28000
60 – 200
5.2
Yes
92
99
5.5
| 37 |