Service / Maintenance / Repair; Explanation Of The Pictograms On The Machine - Baier BDB 825 Mode D'emploi

EN
•
Remove all setting tools, spanners and
installation materials not required before
switching on the drill or drive unit.
Setting tools, spanners and installation materials
located in/on a rotating part of the unit can result
in injuries.
•
Do not overload the drill stand and do not
use it as a ladder or scaffolding.
Overloading or standing on the drill stand can
cause the centre of gravity of the drill stand to
move upwards and the drill stand overturns.
•
Do not use any accessories that have not
been especially provided and recommended
for this drill stand by the manufacturer.
Just because you can attach accessories to your
drill stand is not a guarantee of safe use.
•
Additional signs or other, non-BAIER-
specific parts must not be screwed or
riveted onto the drill stand.
This could damage the drill stand and cause
malfunctions to occur.
•
Note and follow all safety and work
instructions for the accessories used.
•
Never place the feed crank handle on the
hexagon of the tapered shaft to tighten it.
Excessive torques could damage it.

2.6.9 Service / Maintenance / Repair

•
Have the power tool checked if it has been
dropped or become wet.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using
the power tool again, have it checked by our
customer service or an authorised service
centre of Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised service centre
of Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
NOTE
When using new carbon brushes, the machine may
only be operated within the green range for the first
15 minutes - observe LED display in the handle
(Item 1 and 2, see Figure
| 36 |
1 ).
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.
2.6.10 Explanation of the pictograms
on the machine
The CE mark on a product means that the
product conforms with all the applicable
European regulations and has been
subjected to the prescribed conformity
assessment procedures.
Protection class I equipment
The machine is insulated in such a way
that it has no exposed metal parts that
could be live in the event of a fault. An
additional safeguard becomes active if the
basic insulation fails.
Environmentally friendly disposal of
waste equipment
Waste equipment contains valuable
recyclable materials which should be
reused or recycled. Batteries, lubricants
and similar materials must not be allowed
to get into the environment.
Therefore, please dispose of waste
equipment through suitable collection
systems.
Wear hearing protection!
The typical A-weighted sound pressure
level of this power tool is over 85 dB (A)
– wear ear protectors when working with
the tool!
Read the instruction manual!
Before starting any work with or on the
machine, this instruction manual, the
safety instructions and the warnings must
be read through carefully and observed.