Technical Characteristics; Technical Specifications - Baier BDB802 Mode D'emploi

3

Technical Characteristics

3.1

Technical specifications

Wet diamond drill type
Manufacturer
Operating voltage (V / Hz)
Power consumption (watt)
Protection class
-1 1)
No-load speed (min )
Wet core drill bit diameter, hand-guided (mm)
Bit holder
Water tank
2)
Weight (kg)
Speed electronics
3)
Sound measurement
L (sound pressure) dB (A)
pA
L (sound power) dB (A)
WA
Vibration measurement:
Rear handle (7)
1
1) The given speeds are to be viewed as maximum speeds for the given wet diamond bit diameters. De-
pending on the property of the material to be drilled, such as concrete with steel reinforcement of differ-
ent thicknesses, the speed is set "by feel". When drilling through concreted in steel with large wet diamond
core drill bit diameters the 1st gear is always set.
2) Weight according to EPTA procedure 01/2003.
3) Measured values for noise determined according to EN 60745. Wear hearing protection!
Total vibration values (vector sum in three directions) determined according to EN 60745
4)
The vibration emission values given in this instruction manual have been measured according to a meth-
od of measurement standardised in EN 60745 and can be used for comparison between power tools. They
are also suitable for a preliminary estimate of the vibratory stresses.
The vibration emission values given represent the main applications of the power tool. If the power tool is
used for other applications, with different insert tools or are insufficiently serviced, this can significantly in-
crease the vibratory stresses over the whole work period. For a precise estimate of the vibration emission
values, the times during which the tool is switched off or is running but not actually in use should also be
taken into account. This can reduce the vibration stresses over the whole work period significantly.
WARNING
Health risk due to vibrations.
Î Additional safety measures should be taken to
protect the user, e.g. wearing anti-vibration pro-
tective gloves, correct maintenance of power
tools and insert tools, keeping hands warm and
good organisation of work sequences.
K = 3 dB
4)
K = 1.5 m / s
/ (3) m / s 2
2
BDB 802
Maschinenfabrik OTTO BAIER GmbH
~230 / 50 / 60
1. Gear 2. Gear
4200 7500
20 – 40 6 – 20
included
4.0
Yes
91
100
2
2.6
BDB 802B
800
/ I
1st gear 2nd gear
4200 7500
20 – 40 6 – 20
G½ inch
no
3.5
Yes
91
100
2.6
| 35 |