Eu Declaration Of Conformity; Machine Characteristics; Machine Parts And Controls - Baier BDB802 Mode D'emploi

EN
3.2

EU Declaration of Conformity

We herewith declare, with sole responsibil-
ity, that this product conforms to the follow-
ing standards or normative documents:
EN62841-1:2015+AC:2015
EN62841-2-1:2018
EN62841-3-6:2014 + AC:2015 + A11:2017
EN55014-1:2017
EN55014-2:2015
EN IEC 61000-3-2:2019
EN61000-3-3:2013
In accordance with the provisions of the Di-
2006/42/EC
2011/65/EU
in conjunction with the safety instructions
documented in the instruction manual and
the specified intended use.
The factory manager is authorised to write the tech-
nical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
71679 Asperg
Germany
Thomas Schwab
Managing Director
Asperg, 02.04.2020
3.3

Machine characteristics

The wet diamond drills are only approved for wet
drilling. They have electronic speed control, i.e. the
speed increases with the pressure on the ON / OFF
switch.
The wet diamond core drill is equipped with a per-
sonal protection switch (PRCD).
| 36 |
rectives
Robert Pichl
Factory Manager
3.4

Machine parts and controls

Wet diamond drill BDB 802
1
1 Piston pump
2 Lock nut
3 Water tank
Marking: maximum water fill level
4
5 Lock for ON / OFF switch
6 ON / OFF switch
7 Handle
8 Gear change knob
9 Connection cable
10 Personal protection switch PRCD
11 BAIER drill core ejector 1.5 RD
12 BAIER drill core ejector SW3
13 Open-ended spanner SW22/24
14 Open-ended spanner SW27
15 Water feed valve
16 Flow control valve for flushing water
17 Plugs for external water connection (see "Tools
and Accessories" on page 43 or BAIER cat-
alogue)
18 Additional handle (accessories, see "Tools and
Accessories" on page 43 or BAIER cata-
logue)
19 Output shaft
20 Sliding sleeve for locking and unlocking the
quick-change adapter
21 Valve block
Wet diamond drill BDB 802B
2
1 Lock for ON / OFF switch
2 ON / OFF switch
3 Handle
4 Gear change knob
5 Connection cable
6 Personal protection switch PRCD
7 BAIER drill core ejector 1.5 RD
8 Open-ended spanner SW22/24
9 Open-ended spanner SW27
10 Water connection with stopcock and Gardena
coupling
11 Additional handle (accessories, see "Tools and
Accessories" on page 43 or BAIER cata-
logue)
12 Output shaft
13 Sliding sleeve for locking and unlocking the
quick-change adapter
14 Rotary swivel