Technical Characteristics; Technical Specifications; Eu Declaration Of Conformity; Controls - Baier BST 420 Traduction Du Mode D'emploi Original

3

Technical Characteristics

3.1

Technical specifications

Drill stand
Manufacturer
Maximum drilling stroke
Maximum diameter drilled
Maximum usable length
Maximum motor output
Maximum inclination angle
Height
Width
Depth
Weight
Fastening drive unit/drill on the feed slide via the
mounting plate
3.2

EU Declaration of Conformity

We confirm with sole responsibility that
these products comply with provisions of
the Directives:
2006/42/EC (Machinery Directive)
2011/65/EU (RoHS Directive)
in conjunction with the safety instructions
documented in the instruction manual and
the specified intended use.
The head of development is authorised to write the
technical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
71679 Asperg
Germany
Thomas Schwab
Managing Director
Asperg, 06.07.2020
Robert Pichl
Factory Manager
BST 420
Maschinenfabrik OTTO BAIER GmbH
Ø 750 mm
Ø 420 mm
Ø 570 mm
3.3 kW
55 °
Ø 1060 mm
Ø 460 mm
Ø 500 mm
19 kg
Yes
3.3

Controls

Drill stand BST 420
1
1 Feed slide
2 Locking pin
3 Tube lock
4 Hexagon head screw M12x110
5 Capstan handle
6 Eccentric shaft
7 Steel baseplate
8 Hexagon head screw M12x120
9 Adjustable foot
10 Nut M12 (concealed)
11 Slot nut
12 Cheese head screw (4x)
13 Drill stand column with toothing
3.4

Intended use

The drill stand is intended for holding diamond drills
with a maximum power of 3.3 kW in conjunction
with wet diamond core drill bits and a water supply
for wet drilling or with dry diamond core drill bits in
for dry drilling mineral materials such as concrete,
reinforced concrete or masonry. The largest allow-
able diameter drilled is 420 mm. Other units, which
exceed these values, may not be used. The drill
stand can be attached to the floor and to the wall
with the help of plugs / anchors or vacuum.
| 21 |