Black & Decker KS801SE Mode D'emploi page 7

Position 0: metal and aluminium and sheet metal (no pendulum action).

Position 1: for laminates, hard wood, work tops.

Position 2: for plywood and PVC/Plastics.

Position 3: for soft wood and fast cutting

To adjust the pendulum action:
Rotate the Pendulum Stroke dial (6) to the required position.

Sawing
Hold the tool  rmly with both hands while cutting.
The shoe plate (4) should be held  rmly against the material being cut. This will help prevent
Auto Select™ dial ( g. F - KS801SE and KS901SE only)
The KS801SE and KS901SE are  tted with a unique Auto Select™ Dial (6) to set the speed and the pendulum action
for various cutting applications.
To select the optimum speed and pendulum action for the type of material being cut, rotate the dial (6) as shown
in the table below:
PVC
the saw from jumping, reduce vibration and minimise blade
breakage.
Let the blade run freely for a few seconds before starting

the cut.
Apply only a gentle pressure to the tool while performing

the cut.
Hints for optimum use
Straight Assist Blade
When you require a straight cut with extra precision, use the
straight assist blade. The KS901SE/PE is supplied with this
blade as standard and it can be purchased as an optional
extra for use with the KS801SE (part number X21001-XJ).
Anti-Splinter Guard ( g. G - KS901SE only)
To minimise splintering, use the anti-splinter guard supplied
Icon Speed Pendulum
Slow No
Medium Medium / low
PVC
Fast Maxiumum
Fast Medium / low
Fast No
with your product. This reduces the open area between the
shoe and the blade without restricting your view of the cut line.
To  t the anti-splinter guard:




Sawing laminates
When cutting laminates, splintering may occur which can
damage the presentation surface. The most common saw
blades cut on the upward stroke, therefore if the shoe plate is
sitting on the presentation surface either use a saw blade that
cuts on the downward stroke or:


(Original instructions) (Original instructions)
Application
Straight and curved cuts – sheet metal, tin plate,
ceramic tiles and  breglass sheet
Straight and curved cuts – hardwood, decking,
 ooring, plastic, pexiglas and PVC
Straight cuts – general lumber and softwood
Straight and curved cuts – plywood and wood panels
Straight and curved cuts – countertops, laminate
boards, scrolling, curves and craftwork
Remove the blade (see  gure A).
Line up the anti-splinter guard (13) with the shoe plate (4)
from underneath.
Press down onto the shoe plate until the guard clicks in
place.
Replace the blade.
Use a  ne-tooth saw blade.
Saw from the back surface of the workpiece.
ENGLISH ENGLISH
7 7