Assembling The Heater; Installation - Qlima PEW 3015 Manuel D'utilisation

ASSEMBLING THE HEATER

INSTALLATION

•
•
Installation
4
24
The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
The use of this product and the elements required for that purpose is entirely
at the end user's own risk.
Make sure to mount the appliance only on a firm and sturdy underground. In
case of doubt have underground checked by an expert.
WARNING - this appliance must be connected to an earthed power socket.
The heater is fitted with a supply cable and molded plug, therefore the ter-
minals should not be interfered with. The following points should be consi-
dered when positioning the heater:
Please observe the minimum safe distance between the heater body and any
inflammable surfaces. (See Fig 1).
Do not position the heater at an angle of more than 50°from the rear wall
(See Fig 2).
5
Fig 1
1. Securely fasten the bracket to the
mounting surface using the fixing
in the bracket (See Fig 3).
2. Fix in the required angular position
by tightening the fixing bolt on the
bracket at the rear of the heater.
3. The bracket can be used to adjust
the direction of the heater up and
down (See Fig 4).
This is done by loosening the bolts fixing the heater to the bracket, and
then retightening once the correct position is achieved.
Fig 2
Fig 3