Insert Holder; Height-Adjustable Insert Holder (Roughing Unit); Precision Boring Tool 337 And 537Digital - WOHLHAUPTER Alu-Line Série Mode D'emploi

3.2 Insert holder

Various insert holders for forward
machining, for chamfering, for
reverse machining and for outside
turning are available (pages 3+29).
Fastening:
The insert holder is fastened on the
serrated slide with serrated front
face using cap screws and clamping bolts.
As an adjustment aid, there are scales on
the insert holders and serrated slides.
With series Basic D 60, Ø 200 – 505 mm
(7.87 – 19.88"), a cover plate can be fitted
to protect the serrated body during
+0,9
–0,5
roughing (page 25).
3.3 Height-adjustable insert
holder (Roughing Unit)
The height-adjustable insert
holder is generally used with the
precision boring tool 337 or 537
digital for combined rough
machining/finish machining
(Combi-Line). However, the height-
adjustable insert holder can also be
used for two-edge roughing or for a
stepped cut.
The height-adjustable insert holder
consists of a support
;
holder .
Fastening:
The height-adjustable insert
holder is fastened on the
serrated slide with serrated
front face using cap screws
and clamping bolts. As an
adjustment aid, scales are
engraved on the serrated
slides and the height-
adjustable insert holder.
The support of the height-
adjustable insert holder
features a second serrated body on which
the insert holder is fastened.

and an insert
+0,9
–0,5
;

Height adjustment (axial):
To do this, loosen the fixing screw
adjust the insert holder with the adjusting
%
screw in the range + 0.9 to -0.5 mm.
Then tighten the fixing screw again.
3.4 Precision boring tools
The precision boring tool assembly
comprises a precision boring tool
)
insert holder
(
elements .
Two different precision boring tools are
available:
30
)
/ (
Precision boring
tool 337
Fastening:
The clamping elements (supplied as
standard) of the serrated slides are to be
replaced with the clamping elements for
the precision boring tools.
The precision boring tool is fastened on
the serrated slide with serrated front face
using cap screw
clamping bolt
side of the clamping bolt has to be
%
mounted turned away from the cutting
edge, with the flat part pointing in the
direction of the screw head. As an
adjustment aid, there are scales on the
serrated slides holders and precision
boring tools.
Operation of precision boring tools:
see separate operating instructions
for 102 586.
English
and the clamping
)
&
§
/ (
Precision boring
tool 537digital
+ §
, disc spring
/
. Please note: the long
=
and
&
, an
30
&
and
23