Publicité
Les langues disponibles
Les langues disponibles
en
Reversible shredding disc – coarse/fine
for shredding vegetables, fruit cheese, except
for hard cheese (e. g. Parmesan).
Process at setting 3 or 4.
fãéçêí~ å í= á åÑ ç êã~ í áçåW
qÜÉ= ê ÉîÉêëáÄäÉ= ë ÜêÉÇ Ç á åÖ= Ç á ëÅ = á ë= å çí= ë ì á í~ Ä äÉ=
Ñ ç ê= ë ÜêÉÇ Ç á åÖ= å ì í ëK= p ÜêÉÇ = ë çÑ í = Å Ü ÉÉëÉ= ï á íÜ=
íÜÉ Å ç ~ ê ëÉ= ë áÇ É = ç åäó= E ~ í = ë ÉííáåÖ= Q FK
Grating disc – medium-fine
for grating hard cheese (e.g. Parmesan),
cooled chocolate and nuts.
Process at setting 4.
fãéçêí~ å í= á åÑ ç êã~ í áçåW
qÜÉ= Ö ê~ í áåÖ= Ç á ëÅ = á ë= å çí=
ëçÑ í Å Ü ÉÉëÉ= ~ å Ç = Å Ü ÉÉëÉ= ë äáÅ É ëK
Figure C
"
Place the bowl on the base and rotate
all the way in an anti-clockwise direction.
Lug (1.) must engage in the slot (2.) on the
handle (Fig. C4).
"
Place slicing or shredding disc with the
required side face up on the disc holder.
Carefully take hold of discs by the
edge!
Note:
Only one side of the grating disc can
be used.
"
Insert the disc holder. In doing so, hold
the hub (Bild C6).
"
Attach cover (note mark) and rotate
in an anti-clockwise direction as far
as the cover lug (1.). Cover lug must
engage in the slot (2.) on the handle
(Fig. C7).
"
Place multi-blender on the drive, paying
attention to the mark. Rotate the bowl
as far as possible in an anti-clockwise
direction.
"
Turn the switch to the required setting:
Setting 1 or 2 for soft and crumbly foods,
otherwise setting 3 or 4.
"
Put food to be processed in the filling shaft
and push down gently with the pusher,
observe filling height. The maximum filling
height is located on the lower edge of
the disc holder hub.
Tip:
To ensure evenly cut ingredients, process
slender ingredients in bunches.
Robert Bosch Hausgeräte GmbH
ëì á í~ Ä äÉ= Ñ ç ê= Ö ê~ í áåÖ=
Note:
If ingredients to be processed become
jammed in the multi-blender, switch off the
food processor and pull out the mains plug.
Wait until the drive comes to a standstill.
Take multi-blender off the drive, remove cover
from the multi-blender and empty filling shaft.
After using the appliance
"
Switch off the appliance with the rotary
switch.
"
Pull out the mains plug.
"
Rotate multi-blender in a clockwise
direction and remove from the appliance.
"
Remove the cover by rotating it in
a clockwise direction.
"
Remove disc holder with attached
cutting disc.
"
Empty multi-blender.
"
Rotate the bowl in a clockwise direction
and remove from the drive base.
"
Clean parts.
Cleaning and servicing
All parts, except the drive base, are dish-
washer-proof.
Do not wedge plastic parts in the dishwasher
as they could warp.
Insert chopping blade with the tapered
opening face down to prevent other parts
from becoming damaged.
Wipe drive base with a damp cloth. If required,
use a little washing-up liquid. Then wipe dry.
Subject to change without notice.
5090 471 837 | 01.2008
7
Publicité
