Main Window - Quick CHC1103 Manuel D'installation

CHAIN COUNTER OPERATION
EN
CHAIN COUNTER OPERATION
Three elements are employed between user and counter interface:
A GRAPHIC DISPLAY, CONTROL KEYS AND BUZZER.
The graphic display screen shows the measure of chain lowered, state of the chain
counter along with other information.
The control keys comes with three keys. The two side keys are used to move the anchor
p
up ( , UP key) or down (
value of parameters.
=
The middle key ( SELECT) is used to select the monitoring mode, go to the system
menus or confirm parameters.
The buzzer signals when the keys have been pressed or when it is necessary to call the
user's attention.
Use the switch on the power supply line to turn the chain counter on and off.
When the chain counter is turned on, the following window is displayed for a few seconds:
When the chain counter is turned on the first time, the menu used to select the language
in which messages are displayed appears.
The selected language can be changed later on.

MAIN WINDOW

Once the initialization procedure has been completed, the main window is displayed:
State line
Count line
Monitor line
This window is divided into the following sections:
Count line
Measure unit area
State line
Icon area
Monitor line
28
q
, DOWN key), move within the system menus or modify the
STOP
35.3
SPEED
The length of the chain lowered is shown in this area.
The unit of measurement currently being used is shown in this area. The values may be
displayed in "M" for meters and "FT" for feet.
Messages regarding the state of the chain counter or faults detected are shown here.
The icons regarding the state of the chain counter or faults detected are shown here.
The following information may be displayed here, depending on the selections made by the
user: supply voltage and chain speed.
STOP
Icon area
M
Measure unit area
OM/M
CHC1103
CHAIN COUNTER
CHC1103 IT EN FR - REV001A