Installing Filters, Grease Troughs, And Heat Lamps - Thermador Professional Série Manuel D'installation

Installing Filters, Grease Trays, and Heat Lamps
• Remove all plastic from hood pieces.
• Insert in the following order:
1) Grease Tray — Push up and in over the rear lip.
2) Filters — Slide filter over the front lip. Push filter
rear up, then slide back over rear lip.
3) Side Panels — Insert these the same way as the
filters.
1
2
Side
panel
Grease Tray
Reverse the above directions to remove the grease tray, fil-
ters and side panels (Figure 24).
Note:
Depending upon the size and model of hood, there will be
from 1 to 3 filters per hood.
Note:
Do not use cooktop while hood is disassembled. Grease
trays must be in place before installing the filters.
1
2
Filters
Side
panel
Figure 24: Filter Installation
Heat Lamp Replacement (some models)
• Turn heat lamp clockwise to install (Figure 25).
• Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
The PAR-38 175W heat lamp provides a tighter seal within
the enclosure and produces the same amount of effective
heat with lower energy consumption. These lamps may not
be readily available at local retail outlets. The PAR-40
250W heat lamp is more widely available. It can be used
instead.
PAR-38 175W heat lamps can be purchased through the
following retailers:
• OpTech Inc: 800-848-6624 or
www.optechlightbulbs.com
• bulbs.com: 888-455-2800 or www.bulbs.com
Figure 25: Heat Lamp Replacement
English 15