Milwaukee 0822-20 Manuel D'utilisation page 3

FUNCTIONAL DESCRIPTION
3
6
4
1
1. Trigger
2. Control switch
3. Application selector collar
4. Keyless chuck
5. Side handle
6. Torque selector collar
7. Speed selector
Capacities
Flat Auger
Steel
Bit Bit
0824-20 1/2" 1-1/2" 1-1/8"
0822-20 1/2" 1-1/2" 1-1/8"
page 4
7
5
2
Wood
Twist Hole Screws
Masonry
Bit Saw (dia.)
1/2" 2-9/16" 1/4" 1/2"
1/2" 2-9/16" 1/4" N/A
Symbology
Direct Current
Underwriters Laboratories, Inc.,
United States and Canada
No Load Revolutions per Minute (RPM)
Specifi cations
Cat. No. Volts DC No Load RPM
0824-20 18 0 - 450 / 0 - 1700
0822-20 18 0 - 450 / 0 - 1700
ASSEMBLY
WARNING
Recharge only with the charger
specifi ed for the battery pack. For
specifi c charging instructions, read
the operator's manual supplied with
your charger and battery pack.
Removing Battery Pack from Tool
Push in the release buttons and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool
The battery pack can be inserted into the
tool in two ways. To insert the battery pack
onto the tool, slide the pack onto the body
of the tool. Make sure it latches securely
into place.
For working in restricted spaces, insert the
battery pack from the front of the tool.
For optimum weight distribution and
balance, insert the battery pack from the
back of the tool.
No Load Blows per
Minute
0 - 7200 / 0 - 27,200
N/A
WARNING
Always lock trigger or remove
battery pack before changing
or removing accessories. Only
use accessories specifically
recommended for this tool. Others
may be hazardous.
WARNING
To reduce the risk of injury, always
use a side handle when using this
tool. Always brace or hold se-
curely.
Installing the Side Handle
1. To install the side handle, loosen the
side handle grip until the ring is large
enough to slide over the selector collars.
Rotate the handle to the desired position
and tighten the side handle until it is
secure.
2. To remove the side handle, loosen the
side handle grip until the ring is large
enough to slide off the tool.
page 5