Safety Regulations; Layout; Proper Use; Technical Data - EINHELL BG-CT 18/1 Li Mode D'emploi D'origine

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the warning signs on the ma-
chine (Figure 17)
1: Caution!
2: Wear safety goggles!
3: Protect from the damp!
4: Read the directions for use before putting into
operation for the fi rst time!
5: Keep third parties away from the danger
zone!
6: The tool runs on after being switched off !
2. Layout (Fig. 1/2)
1. Safety lock-off
2 ON/OFF switch
3 Fastening screw
4 Additional handle
5 Height adjustment bar
6 Edge guide
7 Thread spool
8 Safety hood
9 Blade
10 Battery charger
11 Battery
12 Assembly tool
Anleitung_BG_CT_18_1_Li_SPK7.indb 16 Anleitung_BG_CT_18_1_Li_SPK7.indb 16
GB

3. Proper use

The equipment is designed for cutting the edges
of lawns and small areas of grass in private and
hobby gardens.
Tools for private and hobby gardens are not sui-
table for use in public facilities, parks and sport
centers, along roadways, on farms or in the fore-
stry sector. For the tool to be used properly it is
imperative to follow the instructions set out in the
manufacturer's directions for use.
Important! It is prohibited to use the tool to
chop material for composting because of the
potential danger to persons and property.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Speed n : ............................................8,000 min
0
Cutting range: ..............................25 cm diameter
Max. running period: ..................... approx. 35 min
Sound power level L : ........................... 85 dB(A)
WA
K uncertainty: ........................................... 3 dB(A)
Sound pressure level L : .................... 69.2 dB(A)
pA
Replaceable battery: ............. 18 V d.c./1300 mAh
Handle vibration a : ............................≤ 2,5 m/s
hv
K uncertainty ...........................................1.5 m/s
Weight.........................................................1.9 kg
Power supply unit:
Mains voltage: .............. 100 V-240VAC, 50-60 Hz
Output:
Rated voltage: .........................................24 V d.c.
Rated current: .......................................... 350 mA
- 16 -
-1
2
2
03.05.12 11:05 03.05.12 11:05