Fault And Remedy - Matrix Pgt 3 In 1 Traduction De La Notice Originale

9. Fault and remedy

The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If the problem still persists after working through the list,
please contact your nearest service workshop.
fault
The equipment does not
start
The tool starts, but the
engine has little power.
The engine does not run
smoothly
Engine smokes excessively
Saw chain is dry
Chain/guide bar is hot
Chainsaw judders, vibrates
or does not saw properly
possible Cause
- Correct starting procedure
not followed
- Soot or damp spark plug
- Incorrect carburetor setting
- Incorrect choke lever setting
- Air filter is dirty
- Incorrect adjustment of
carburetor
- Spark plug is full of soot,
Incorrect electrode gap on the
spark plug
- Incorrect carburetor setting
- Gasoline filter plugged up
- Incorrect fuel mix
- Incorrect carburetor setting
- Incorrect air gap at spark
plug or spark plug burnt down
- No oil in the tank
- Vent in the oil tank cap is
blocked
- Oil outlet blocked
- No oil in the tank
- Vent in the oil tank cap is
blocked
- Oil outlet is blocked
- Chain is blunt
- Chain is over-tensioned
- Chain is under-tensioned
- Chain is blunt
- Chain is worn
- Saw teeth point in the wrong
direction
Troubleshooting
- Follow the instructions for
starting
- Clean the spark plug or replace it
with a new one
- Have the carburetor adjusted by
a technician.
- Set the choke lever to „
- Remove the filter made of
foamed plastic, wash in soapy
water and reinsert when dry.
- Have the carburetor adjusted by
a technician.
- Clean the spark plug and adjust
the electrode gap, or fit a new
spark plug
- Have the carburetor adjusted by
a technician.
- Clean or replace gasoline filter
- Use the correct fuel mix (see fuel
mixing table)
- Have the carburetor adjusted by
a technician.
- adjust the electrode gap or
replace the spark plug
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Re-sharpen or replace the chain
- Check the chain tension
- Adjust the chain tension
- Re-sharpen or replace the chain
- Replace the chain
- Refit the chain with the teeth
facing in the correct direction
".
75