Cleaning, Maintenance And Storage - Matrix Pgt 3 In 1 Traduction De La Notice Originale

8. Cleaning, maintenance and storage

INJURY WARNING: Always wear
protective gloves when working on
or around cutting tools.
To avoid the risk of accidental start,
disconnect the spark plug cap.
8.1 Cleaning
Use a moist piece of cloth to clean the plastic
parts.
Do not use any cleaning agents, solvents, or
sharp objects.
During the course of work, wet grass and weed
wraps around the drive shaft below the cutting
guard for technical reasons. Remove this,
otherwise the engine will overheat because of
too much friction.
8.2 Regular checks
Keep in mind that following specifications relate
to normal usage. Owing to circumstances (longer
periods of daily work, severe dust exposure,
etc.), the specified intervals will become
correspondingly shorter.
Before start of work and after refueling: Check
if cutting tools are seated securely, general
view inspection, sharpen cutting blade (also, if
necessary).
Weekly inspection: Lubrication of gear (also, if
necessary).
If necessary: Retighten accessible fastening
screws and nuts.
You will avoid excessive wear and tear and
damages of the tool, when you follow the
68
instructions in this manual.
The user is responsible for all damages caused by
non-compliance with instructions in this manual.
This also applies to non-authorized modifications
of the tool, use of non-authorized spare parts,
accessories, working tools, unrelated and not
intended use, secondary damages due to use of
faulty components.
8.3 Wear Parts
Even when used in the intended way, some
components are subject to normal wear. They
have to be replaced depending on the kind of
duration of usage. These parts include, among
others, the cutting tool and the retaining disk.
Adjustment of Carburetor
The carburetor was adjusted to optimum
performance in the factory. Should readjustment
be necessary, please contact a service center.
8.4 Storage / Hibernate Cleaning, storage,
transport
Clean and maintain the equipment before
storage.
• Regularly clean the tensioning mechanism by
blowing it out with compressed air or cleaning it
with a brush. Do not use any tools for cleaning.
• Keep the handles free of oil so that you can
maintain a firm grip.
• Clean the equipment as required with a damp
cloth and, if necessary, mild washing up liquid.
• If you are not going to use the chainsaw for an
extended period of time, remove the chain oil
from the tank. Briefly immerse the saw chain and
the cutter bar into an oil bath and then wrap
them in oil paper.