Telcoma Automations T400 Instructions Pour L'installation page 47

GB
PROGRAMMING WORK AND PAUSE TIMES
During programming the control unit has a self-learning capability with regard to work and pause times.
The S/S command will be activated several times during programming (item 7 of Fig. 1), alternatively the PP
command can be used (terminal 8 if Fig. 2 or the remote control (if stored). There are two types of installation and
different mode:
1) Installation with limit switches.
During programming the limit switch activates to determine the limit of gate movement. Follow type 1 for
programming.
2) System without electric limit switches.
During programming, encoder activation (if present) determines the gate manoeuvre limit.Follow type 1 for
programming.
3) If there are NO electric limit switches or encoders, the times must be set via the drive of the S/S command.
Follow type 2 for programming.
Important notes before programming:
A. Power the control unit and check correct operation of the control inputs through the relative LEDs (the N.C.
contact LEDs should be on).
B. Free the area of gate movement.
FULL opening programming: Typology 1.
AUTOMATION WITH ELECTRIC LIMIT SWITCHES
1) Shut off power supply to control unit
2) Position the gate or door at mid-travel.
3) Press PROG/STOP button
seconds.
Programming LED L1 comes on.
backwards, cut off the power, invert the motor phases and the limit switches and repeat the procedure.
8,9) Once the motor has reached the stroke limit, it stops and then the opening stroke starts automatically.
10) Once the opening stroke is complete, the motor stops. The control unit starts the pause time registration phase.
11) Once the desired pause time has lapsed, press the P/P button. The motor then starts the closing manoeuvre.
12) Once the closing stroke is complete, the motor stops. End of programming, led L1 switches off.
47